1. Any American-made mini pick-up, compact SUV, vehicles are permitted.

2. Any 4-cylinder or 6-cylinder engine.
(If it has door midpalate, the firewall must be cut wide as the headers or engine block.)

3. Fuel tanks must be located in the bed of the truck in the center of the bed directly behind the cab. Fuel cells must be securely fastened and covered. Mini Vans must be mounted inside in a safe manner between the 2"'Crow doors. (NO FACTORY GAS TANKS)

4. Battery must be moved inside and mounted safely.

5. All Trucks/ Vans must have/8 seat belts.

6. Doors. tailgates and hatches must be secured by wire, chain, or welded shut no loose doors are permitted. 6 on 6 off.

7. Box and cab mounts may be replaced with up to 1• bolts body mounts may be removed. The body bolts may go all the way through the frame and floor of the truck/mini van.

8. No trailer hitches or reinforcements of frame or body of any kind permitted.

9. May use any loaded factory car bumper or homemade bumper that is a 6x6 box tube with no more than 4" point over a 32" wide
- For mounting of car bumpers, you may use factory bumper shocks and brackets or a 3"x3"x6" long
box steel or likewise material.

10. Hoods must be in place and must have a 12" x12· hole cut-in hood over the carburetor engine.

11. Hoods may be wired or bolted shut-in 6 locations, Boltscanbeupto¾"double strands of wire permitted.

12. No 4- wheel drives permitted. 4 Wheel drives must have the front-drive shaft removed.

13. Tires are black and round

14. Beds must be welded to the cab of trucks with a 3" strap directly behind doors.

15. Front suspension may be solid with 2x2 straps on an a-arms or solid spacer on the strut/ welded strut.
- No homemade struts.
-All other suspensions must remain factory. (Tie rods, ball joints, rack, pinion, etc.)

16. A 4-point cage is mandatory in the driver's compartment for driver safety. The cage In the cab may have 4 down legs from the front and rear bar straight down to the top of the frame. Also, a gas tank protector is recommended.

17. Trucks must set level no pulling down the rear of the truck. No smashing of the bed sides permitted. You must use factory springs for the make and model of the truck. You may use a chain on the rear axle to secure ride height

18. You may run aftermarket or homemade steering column, floor mount brake pedal, gas pedal, or shifter. trans cooler, slider drive shaft, and carb conversions are ok.